A waste pullout for one can or two — fully parametric, so it builds around the can you actually own. Apertures cut to the rim, profiled sides, nested and toolpathed off one sheet.
That is the whole argument, and it is the trade price I am comparing against — not the inflated list. A wood pullout is a box, some hardware and an afternoon. Laying one out to fit a specific opening is the part nobody wants to do twice, and that is the part this does.
| List | Trade | |
| Rev-A-Shelf 4WCSC 18" maple, 2 x 50 qt | — | $335.79 |
| Rev-A-Shelf 4WCSC 15" maple, 2 x 35 qt | — | $306.69 |
| Rev-A-Shelf 4WCBM 14 1/4" maple, 2 x 35 qt | — | $286.89 |
| Built on your machine, from about half a sheet of 12 mm ply | material only | |
I only pulled trade pricing on the waste units; list runs higher, the way it does on the rows above. Wood bottom-mount doubles are the like-for-like — metal-basket units are cheaper and a different thing. Prices checked 17 August 2026 at a cabinet supplier. Take the trade column as the real number — list exists partly to make the trade discount look good, and if you are cutting these you have an account. Either column is more than a sheet of ply.
Type the count. Two cans stack fore-and-aft, one turns sideways, and the orientation is derived from the number — you do not pick it and you cannot get it backwards.
The defaults are the RV-35-17-96: 14 3/8 x 10 1/2 rim, 17 7/8 tall, aperture 12 x 8 3/16 with a 7/8 corner radius. Every one of those is a field. Measure the can in your hand and type it in.
Cans taper. The hole is a measured property of the can, so the rim carries the load and the body clears.
The door hangs off it, and a full 35-quart can is a real load. Front 15", back 11 1/4", both flush with the sides.
Flat to R5 to 32° to R5 to flat — generated, not traced, and it rebuilds to the thousandth at any size.
Defaults, not limits. Every one of these is a field you type into — the gadget builds to what you measured, not to what I measured.
| Default opening | 20" wide |
| Cans | One or two, your dimensions — default is two 35 quart, 14 3/8 x 10 1/2 rim, 17 7/8 tall |
| Aperture | 12 x 8 3/16, 7/8 corner radius |
| Front / back height | 15" / 11 1/4", flush with the sides |
| Material | 12 mm ply throughout (sold as 1/2") |
| Slides | Blum TANDEM 563H undermount |
You do not draw anything and you do not edit geometry. Type your opening, your can, your material and your hardware, press Generate, and it lays the parts out on your sheet with the toolpaths posted in cut order — pockets, bores, cutouts, then the part outlines last. It reads your real sheet size out of Job Setup, so the nest is against the material you are actually holding.
OrganizerFORGE, TrashFORGE and SpiceFORGE are $75 each, or $150 for the three. They share a carcass and the same hardware, so if you are cutting one you are set up to cut all of them.
Get the bundle
THE HOMESTEAD WORKSHOP